aluminum panels How to Install Your Own Solar Panels

by:Carlos     2019-04-06
Once you have solar panelsYou need to decide whether to install them in your backyard or on the roof.If you have enough space in the backyardYou don't mind if they get in the way of your view of the gardenThis will be the easiest choice.On the other hand,Most people seem to choose the roof because the panels are outdated.No matter which way you go,A detailed plan is necessary because it will prevent errors,When you apply for a permit, it will also be requested by your construction department

This is one of the best ways to install a panel, because you can install each array on the pole, and you can change the vertical angle of the panel to maximize exposure to the sun, because of the change of seasons.In spring and fall, you should set the angle of the panel to be equal to your latitude.Set the angle in summer minus 15 degrees in latitude and 15 degrees in winter.There are a wide range of options from the pole rack to the ground that can be supplied from the solar energy House.You can even buy a tracking unit that will follow the sun through the day,however,They are expensive and may not generate enough additional power to pay.You can also build your own mounts from locally sourced building materials.One consideration is that most local codes require your panels to be in the fenced yard,Or at least 8 feet kilometers from the ground (2 1/2 meters)So they are not accessible to the public.Solar panels are installed on the roof.The first thing to consider is the angle of the roof.If not Taiping,You can install the panel on the plane of the roof, which is the simplest and most enjoyable from an aesthetic point of view.If the angle of your roof matches your latitude, you are in the perfect shape.Plus or minus 10-15 degrees will also work,But with a bigger change or a flat roof,You will need to build a rack that will angle your panel.The next consideration is the type of roof because you don't want to go to all the trouble to install the solar system and then have a leaking roof.It is easy to install a composition or metal roof because a small roof compound will keep the water,But if you have concrete or tiled roofsYou 'd better have a good roof to help with the installation.The most important thing is to safely Bolt the roof or other frames of the confrontation.You don't want to lose your array in a snowstorm.Make sure the stand-off is correct to flash and seal, so there is no possibility of leakage.About 4 feet of the space confrontation (1 1/3 meters)Except that the bottom track suitable for the aluminum channel is long enough to fit the array.The second rail is then installed to keep the top of the solar panel.Now the panel is ready to install the bracket that is used to slide in the Channel.But first of all, we have to install all the wires and pipes and make sure the track is properly grounded.Wiring and piping are installed.As part of the plan submitted to the construction department, will be a wiring diagram specifying the wire size,Conduit and junction box to use.Keep in mind that the wire size depends on the distance between the voltage and the inverter, determined by the wire size table.I recommend you to use a larger wire as this will reduce heat accumulation and associated voltage loss.Make sure all the connections and boxes are water tight as repairs are often complex at a later time.You are now ready to install the panel and connect it to the cabling.Keep in mind that the panels will generate power once the sun hits them, so make sure you don't connect the inverter and be careful when dealing with any exposed wires.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...